Our website uses cookies to improve its performance and usability. We don't use advertising tracking cookies.
We use some other tools on the website (as data-processors) Further information on our privacy policy

I agree to this usage

.

What is a Blind Corner Wardrobe?

What is a Blind Corner Wardrobe?

A blind corner unit is similar to a double wardrobe, but only has one door. The other door is replaced by a blanking panel. This enables you to put the unit in the corner, and butt another wardrobe up to it, at a 90 degree angle.

It gives you the ability to use the whole space in your bedroom, as the corners of room are otherwise often wasted. 

Units like these are really the key to getting the most out of your bedroom space, so we would definitely encourage you to consider using these. 

Please note, these don’t go right into the corner of your room. You leave a gap of 160mm between the corner and the unit. This allows the doors of both wardrobes to open without catching on the opposite door. 

As with all of bedroom installations, to get the best fit please ensure you plan and prepare. We’ve put some details together below, to help with the installation. Please have a read, or pass on to your bedroom installer, if you’re paying a professional to fit it for you. 

Blind Corner Planning

Corner Planning

The Blind Corner Wardrobe uses a standard double robe as shown.

The corner hinging panel is made in matching door material, and is also pre-drilled on the inside face for a blind corner hinge. The return wardrobe uses a standard single or double cabinet with standard hinges.

Very little is visible of the corner hinging panel once doors are fitted, depend- ing on the edge profile of the chosen door design.

Blind Corner Installation

Installation Instructions

Step 1 – Fit Blanking Panel & Corner Hinging Panel

Fit the chipboard blanking panel to the cabinet top/bottom/end by directly screwing into place (screws not supplied) flush with the cabinet sides - the 100mm Corner Hinging Panel is then similarly fitted into place, creating a 450 mm aperture to one side of the assembly. Note the planning spaces required, by allowing a 160 mm void in the corner. Note – it will be easier to fit the hinge mounting plates to rear face of the corner hin3g0ing0panel at this stage

Step 2 – Form the Return Wardrobe

Use clamp grips to secure the return assembly into position – there should be a consistent 19 mm reveal of the corner hinging panel along it`s full length to allow for the return door. Secure into position via direct screws (not supplied) through the inside face of the blanking panel.

Matt Light Grey Bedrooms
Matt Light Grey Bedrooms
Gloss Light Grey Bedrooms
Gloss Light Grey Bedrooms
Gloss Black Bedrooms
Gloss Black Bedrooms
Matt Black Bedrooms
Matt Black Bedrooms
Matt Green Bedrooms
Matt Green Bedrooms
Baltic Blue Bedrooms
Baltic Blue Bedrooms
Indigo Blue Bedrooms
Indigo Blue Bedrooms
Gloss White Bedrooms
Gloss White Bedrooms
Matt Dust Grey Bedrooms
Matt Dust Grey Bedrooms
Boston Concrete Bedrooms
Boston Concrete Bedrooms
Matt Plum Bedrooms
Matt Plum Bedrooms
Matt Taupe Bedrooms
Matt Taupe Bedrooms